Luxury Renovation Solution · Sheffield & South Yorkshire
Flat Roofing in Sheffield
Flat roofs for extensions, dormers, garages and porches, laid with proper falls and edge detailing.
A flat roof is only as good as its falls, its upstands and its edge trims. Most flat roof failures I see in Sheffield are ponding water caused by inadequate firrings, or a membrane that was never properly dressed up behind the render. Whether it is GRP fibreglass, EPDM rubber or torch-on felt, the deck is rebuilt to fall before anything is laid over it.
Choosing the right system
GRP fibreglass gives a seamless, hard-wearing finish and suits extension and dormer roofs that are on view. EPDM rubber is laid as a single sheet with very few joints and copes well with movement. Torch-on felt remains a cost-effective option for garages and outbuildings. I will explain which suits the roof and the budget rather than fitting one system to everything.
Insulation and Building Regulations
A new or replacement flat roof over a heated space normally has to meet current insulation standards as a warm-deck build-up. That affects roof height and door thresholds, so it is designed in from the start rather than discovered part-way through.
How a flat roofing project runs
- 01
Inspection
Deck, falls, upstands and insulation assessed, and the cause of any existing failure identified.
- 02
Strip and rebuild deck
Old covering removed, deck replaced where soft and firrings set to the correct fall.
- 03
Insulate
Warm-deck insulation installed where the roof covers a heated space.
- 04
Lay the membrane
GRP, EPDM or felt laid with proper upstands, trims and outlets.
- 05
Rainwater and check
Outlets and guttering connected, roof flood-checked and handed over.
Where I work
Flat Roofing work is carried out across Sheffield and South Yorkshire, including Dore, Totley, Crosspool, Fulwood, Ecclesall, Ranmoor, Hillsborough and the surrounding villages, plus Rotherham, Chesterfield, Dronfield and Barnsley. See the full service area.
FAQ
Flat Roofing — common questions
How long does a flat roof last?+
A properly installed GRP or EPDM flat roof typically lasts 20–30 years. Older felt roofs are usually nearer 10–15.
Why does my flat roof hold water?+
Almost always inadequate fall, a sagging deck or a blocked outlet. Recoating without correcting the fall just repeats the problem, so the deck is rebuilt as part of the work.
Can you fit a flat roof over an existing one?+
Occasionally, but only if the existing deck is sound and dry. Overlaying wet insulation traps moisture and shortens the life of the new roof considerably.
Can a flat roof have a rooflight?+
Yes. Fixed and opening flat rooflights are a common addition on extension roofs and are detailed into the membrane with a proper upstand kerb.
Enquire